EZ Dock Hardware
Replacement EZ Dock hardware: hex bolts, truss-head and flat-head bolts, carriage bolts, studs, hex and Nylok nuts, flat washers, brass inserts, hitch pins, curbing screws and hardware kits for EZ Dock benches. Most parts are 18-8 stainless steel, with some zinc-plated and Grade 8 pieces, in common sizes from 5/16 in. to 3/4 in. Blue Ridge Boat Docks, a dock builder in Marion, IL, sells and services EZ Dock floating docks around the Midwest.
Shop by Category
EZ Dock Hardware
Replacement EZ Dock hardware: hex bolts, truss-head and flat-head bolts, carriage bolts, studs, hex and Nylok nuts, flat washers, brass inserts, hitch pins, curbing screws and hardware kits for EZ Dock benches. Most parts are 18-8 stainless steel, with some zinc-plated and Grade 8 pieces, in common sizes from 5/16 in. to 3/4 in. Blue Ridge Boat Docks, a dock builder in Marion, IL, sells and services EZ Dock floating docks around the Midwest.
Filter EZ Dock Hardware by brand
Showing EZ Dock only ×Showing 1–12 of 29 results
EZ Dock Hardware FAQ
What thread sizes does EZ Dock hardware use?
Common EZ Dock thread sizes are 5/16-18, 3/8-16, 1/2-13 and 5/8-11, with a few larger bolts such as 3/4-10. Listings give the thread and length, for example 1/2-13 x 2-3/4 in. Measure the old bolt or check the part list before ordering a replacement.
Why use stainless steel hardware on a floating dock?
Most marine-exposed EZ Dock fasteners are 18-8 stainless steel because it resists rust in the water. Some parts are zinc or yellow-zinc plated or Grade 8 for strength. Replacing like with like keeps the dock's connections from rusting or seizing.
What are truss-head bolts used for on EZ Dock?
Per EZ Dock, truss-head bolts fasten accessories such as bunks and wear strips to molded-in T-nuts. Their wide, low head spreads the load on the polyethylene. Lengths vary by accessory, so match the bolt to the part you are mounting.