EZ Dock Hardware
Replacement EZ Dock hardware: hex bolts, truss-head and flat-head bolts, carriage bolts, studs, hex and Nylok nuts, flat washers, brass inserts, hitch pins, curbing screws and hardware kits for EZ Dock benches. Most parts are 18-8 stainless steel, with some zinc-plated and Grade 8 pieces, in common sizes from 5/16 in. to 3/4 in. Blue Ridge Boat Docks, a dock builder in Marion, IL, sells and services EZ Dock floating docks around the Midwest.
Shop by Category
EZ Dock Hardware
Replacement EZ Dock hardware: hex bolts, truss-head and flat-head bolts, carriage bolts, studs, hex and Nylok nuts, flat washers, brass inserts, hitch pins, curbing screws and hardware kits for EZ Dock benches. Most parts are 18-8 stainless steel, with some zinc-plated and Grade 8 pieces, in common sizes from 5/16 in. to 3/4 in. Blue Ridge Boat Docks, a dock builder in Marion, IL, sells and services EZ Dock floating docks around the Midwest.
Filter EZ Dock Hardware by brand
Showing 1–12 of 29 results
EZ Dock Hardware FAQ
What thread sizes does EZ Dock hardware use?
Common EZ Dock thread sizes are 5/16-18, 3/8-16, 1/2-13 and 5/8-11, with a few larger bolts such as 3/4-10. Listings give the thread and length, for example 1/2-13 x 2-3/4 in. Measure the old bolt or check the part list before ordering a replacement.
Why use stainless steel hardware on a floating dock?
Most marine-exposed EZ Dock fasteners are 18-8 stainless steel because it resists rust in the water. Some parts are zinc or yellow-zinc plated or Grade 8 for strength. Replacing like with like keeps the dock's connections from rusting or seizing.
What are truss-head bolts used for on EZ Dock?
Per EZ Dock, truss-head bolts fasten accessories such as bunks and wear strips to molded-in T-nuts. Their wide, low head spreads the load on the polyethylene. Lengths vary by accessory, so match the bolt to the part you are mounting.